Machining center

SW BAW02-22i

4 Machines Available with identical configuration.
Each machine ahs less than 700 spindle hours !!!

Horizontal twin-table machining center with 2 spindles
SPECIAL MACHINE FEATURES
-Monobloc design
-Linear and torque motor in the feed axes
-Gantry drive in the Y axis
-Mass optimized machining unit Box-in-open-Box
-Workspindle optionally with HSK A40 or HSK E40 taper
Iaedpfx Asu Im Ened Eer
-Double swivel carrier with 2 integrated rotary axes for in-cycle loading / unloading
-Trend-setting technologies that boost energy efficiency
-Central workstation

Description
The BA W02-22 is a horizontal, twin-spindle machining center. Mainly used for 4- and 5-axis machining of small non-ferrous metal workpieces.
The linear and torque motors of the feed axes guarantee with a maximum workpiece accuracy, the highest possible dynamics and very short non-productive times.
In order to ensure loading and unloading in parallel to the machining time, the BA W02 is equipped with a double swivel trunnion

Linear motors
The use of linear motors in the feed axes X, Y and Z makes it possible to achieve speeds of 120 m/min (X- and Y-axis) and accelerations up to 22 m/s² (Z-axis).
Linear motors have significant advantages over conventional drives with ball screws in terms of energy, wear and noise emissions. Three-phase synchronous motors are used in the BA W02-22.

Workspindle
Two different motor spindle types are available with HSK 40 interface for the BA W02-22.
HSK A40, 25,000 rpm:
This synchronous motor spindle features high dynamics. It has a core spindle with a very low mass moment of inertia.
This allows for a very short run-up time to a maximum speed of 25,000 rpm with a constant high torque. This results in a consistently short chip-to-chip time over a speed range up to 10,000 rpm and best times for thread cutting.

TECHNICAL DESCRIPTION OF STANDARD MACHINE - BA W02-22
WORKING RANGE
linear axes
Spindle distance
250
mm
X axis
200
mm
Y axis (tool change position)
350
mm (525mm)
Z axis
300
mm

WORKPIECE CARRIER A/U
Swivel carrier system with plane surface gear teeth (Q-axis) Swivel time 0° / 180° 2.25 s
Max. asymmetrical loading
Repeatability accuracy relative to 500 mm 0.005 mm
Two independent rotary axes (A-axis/U-axis), suitable for holding clamping bridges. The rotary axes, each consisting of a directly driven NC rotary tables with direct and absolute angle measurement and a counter bearing
Max. dimension of fixture/workpiece
425mm x 630mm
Max. weight of fixture/workpiece
160kg
Peak torque (standard)
420 Nm

WORKSPINDLE HSK A40
Liquid-cooled motor spindle based on AC synchronous technology
Speed range 1-25,000 rpm

The listing was translated automatically. Translation errors are possible.