Plasma cutting machine

Microstep Mastercut Eco Plus 3001.15

Condition: good (used), Year of construction: 2016, functionality: fully functional, Microstep Mastercut Eco Plus 3001.15 Year of manufacture: 2016 Controller: IMSNC Cutting table: 3000 x 1500 mm Extraction channel left/right Plasma source: Kjellberg HiFocus 161i, adjustable 10 – 160 A Power Source HiFocus 161i PLUS • Flexible adaptation of the cutting process to required conditions thanks to soft-switch inverter and microprocessor control • Optimal process management with ultra-fast regulation of cutting current • Process monitoring for torch cooling, ignition time, pilot arc time, short-circuit time during torch ignition, and the power source • Display of operating statuses and error messages via LED and display • Analog and serial interface for adaptation to CNC controls • Infinitely variable adjustment of cutting current from 10–160 A; marking current from 5–25 A • Optimal piercing due to stepless delay time for main arc and adjustable current rise • Adjustable current reduction at corners, as well as at start and end signals from guidance systems • Automatic display of preset cutting current • Serial data transfer for PC-based diagnostics Plasma Cutting Technology Contour Cut Csdpfxjyzy S Aj Abbjgt • Further development of HiFocus technology for carbon steel • Optimized for cutting fine internal and external contours • High cut quality and contour precision • Holes with angle tolerances according to DIN EN ISO 9013 within range 2-4 • Low angle deviation and smooth cut surfaces • Very good repeatability and dimensional accuracy • No time-consuming post-processing—high productivity, reduced costs • No additional equipment or software required, and no new wear parts necessary • Supplied as standard Plasma Torch PerCut 200/210 • PerCut 200 machine plasma torch for standard applications and high-precision bevel cutting • Quick-change torch PerCut 210 with threaded connector for fast and comfortable setup • Special torches available for custom applications • Higher cutting speeds reduce cost per meter cut • Long service life of consumables conserves resources • Narrower kerf for less emission and waste • Significantly lower gas consumption compared to the competition through efficient liquid cooling up to the nozzle tip • Lower noise level due to reduced gas consumption • Bevel cutting up to 50 degrees with standard consumables • Cutting and marking possible with the same consumables Technical Data: Power source: HiFocus 161i Connection voltage: 400 V; 3-phase; 50 Hz Max. power consumption: 28 kVA (100% duty cycle) Line fuse: 50 A (slow-blow) Protection class: IP 22 Open circuit voltage: 330 V Cutting current: 10–160 A (100% duty cycle) Marking current: 5–25 A (100% duty cycle) Cutting range: max. 50 mm, recommended 0.5–38 mm Max. piercing thickness: 30 mm Weight: 206 kg Plasma Machine Torch: PerCut 200 Quick-change torch: PerCut 210 Clamping diameter: 50.8 mm Plasma gases: O2, N2, Ar/H2 Marking gases: Ar Swirl gases: O2, N2, air, N2/H2 (F5)