Controller with angle screwdriver

Georges Renault (Desoutter) CVI II

Desoutter CVI II Controller with angle screwdriver

Manufacturer: Georges Renault (Desoutter)
Dcjdpswxv Hkefx Ag Uon
Controller: CVI II
Angle screwdriver : 01C11200

CVI II Controller
From simple start-up operations to complex sequencing applications - with up to 20 phases and 250 cycles - for optimum speed, accuracy and operator comfort with every connection.

The controller has various interfaces, including an Ethernet port, an RS232 port and 7 logic inputs and 8 logic outputs (24 volts).

The CVI II controller can be used to control a hand-held power tool from the ER series or a stationary screwdriving spindle from the EM series.

It is important to note that the CVI II can also be used in combination with a transducer-controlled angle screwdriver such as the Desoutter ERA40J, which has a torque range of 8 to 40 Nm and a 3/8" output.

Memory capacity
Between 2,500 and 8,500 tightening results per station depending on the number of cycles and operating mode (asynchronous or synchronous).

Tightening strategies
- Torque and angle monitoring
- Angle and torque monitoring
- Torque and angle monitoring
- Torque and angle rate
- Predominant torque
- Yield strength
- Standstill torque
- Torque and angle
- Detection of the plastic zone of the joint
- Additional torque and angle sensors
- Self-tapping
- Current monitoring


Connectable tools:
Angle screwdriver / rod screwdriver / gun screwdriver