Lowbed

Fliegl SDS 470 T Standard

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

Chassis, low-loader, semi-trailer
Steel welded construction, kingpin plate with 2 replaceable kingpins and 2 kingpin positions,
24 tons, 2-speed landing gear, single-sided operation, with straight lower section, without thrust compensation
Foldable rear support
2 chock blocks with holder
Aluminum side impact protection
Splash guards at the rear, covering the entire width
Fenders in front of the 1st axle and at the rear of each axle with anti-spray, according to EC
Extendable widening elements to 3,000 mm (not in rear slope)
Storage compartment for wooden planks in the middle of the loading area
Wooden planks 70 mm for widening to 3,000 mm
Tie-down points, low-loader
2 pairs of ring tie-down points, each 5 tons, at the front on the gooseneck
11 pairs of tie-down eyes embedded in the top and side of the outer frame, each 10 tons
2 on the gooseneck
9 distributed in the low-loader area
First tie-down point 250 mm from the front and last max. 250 mm from the rear, distance between tie-down points no more than 1100 mm
Giodpei Ri E Rjfx Acfeu
8 pairs of pocket holes embedded in the outer frame, inner dimensions 70 x 40 mm (can be converted to 5-ton ring tie-down points)
Axles + suspension
SAF drum brake axles
Air suspension
Wheels and tires
235 / 75 R 17.5
Steel rims in twin arrangement, factory silver
Braking system
2-line pneumatic braking system
Color-coded line routing for easy servicing
Spring parking brake
EBS, electronic braking system with EBS socket at the front, without connection cable
2 fail-safe coupling heads at the front, without connection cable
with raise & lower valve
Axle load detection via EBS-CAN bus signal, for display on the dashboard in the driver's cab
Vehicle - driving stability system
Electrical system
24 volts, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red marker lights at the rear
2 x 7-pin fail-safe sockets at the front, without connection cable
1 LED rotating beacon with holder
2 pairs of warning signs, double LED-illuminated and extendable to 3,000 mm
Floor
Gooseneck with steel sheet covering
Storage box embedded in the transition slope to the gooseneck
followed by 70 mm soft wood flooring, steel/diamond plate covering in the wheel arch area
Rear slope with 70 mm soft wood flooring
Low-loader area including rear slope 9,200 mm
Ramps
Steel ramps 2,800 mm long, 750 mm wide, laterally adjustable
covered with wood
Hydraulically operated via tractor PTO with throttle, actuation on the left side in the front
Hydraulic connection with SVK socket NW 10/3, without connection hoses

Custom-made transport solution
Configure your Fliegl vehicle according to your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

The listing was translated automatically. Translation errors are possible.